|
|
|
 We tried to get clear aluminum, but it was on back order. They said it would be in by March 3, 2150. - S.Nickens [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We tried to get clear aluminum, but it was on back order. They said it would be in by March 3, 2150. - S.Nickens [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
02-01-2010, 12:23
|
||||
|
||||
|
Re: Working with Quickframe
Possibly cut it at the point you need a vertical piece and put in a 9230?
http://www.8020.net/Quick-Frame-7.asp This could be a hassle if it is a last minute addition but otherwise if you carefully think through the order in which you are going to piece together your frame I imagine it would work fine. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Working with curved surfaces | Goaliexam | Inventor | 4 | 09-05-2006 14:44 |
| Working with Gyros | DavidSJohnson | Programming | 1 | 10-02-2006 00:16 |
| Working with Lexan | Phil Paspalas | Technical Discussion | 41 | 09-02-2006 16:14 |
| [ECDU]: Working with programmers? | Bcahn836 | FIRST-related Organizations | 5 | 07-03-2005 22:15 |
| Working with Potentiometers | GrahamS314 | Programming | 11 | 02-02-2003 14:34 |
Threaded Mode