|
|
|
 Between reading the Manual, Q&A, Team Updates, the Blog, and Chief Delphi, you can be one of the most valuable members of any team. - Gregor [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Between reading the Manual, Q&A, Team Updates, the Blog, and Chief Delphi, you can be one of the most valuable members of any team. - Gregor [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: [FTC]: Rev 6 of Game Manual Changes Rules on Plastic and Aluminum Sheets
Unless they mean to restrict diagonals, they probably shouldn't use the confusing term "maximum dimension". (It would probably have been better to have said something about each part's perimeter being traced within its own theoretical 24 in side length square, and a total area within all perimeters of less than 576 in2 per material.)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: FIRST Rules Traditions and Practices | Joachim | FIRST Tech Challenge | 8 | 22-10-2009 11:21 |
| Renumbering of rules in rev F and Rev G of section 8 | Joe Ross | Rules/Strategy | 3 | 02-02-2009 21:46 |
| paper: 2006 IRI Rules Changes and Clarifications | Andy Baker | Extra Discussion | 1 | 23-07-2006 02:47 |
| TV Commercial Game - Rules and Regulations | Elgin Clock | Games/Trivia | 6 | 01-12-2004 19:07 |
| 1999 and 2000 Game Rules | Doug G | General Forum | 5 | 16-08-2003 00:58 |
Hybrid Mode
