|
|
|
 Let's see some love for these fine people. Let's give it up for the refs. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Let's see some love for these fine people. Let's give it up for the refs. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
11-01-2010, 12:43
|
|||
|
|||
|
Re: 84 inch diameter vertical right cylindrical volume ?
I have a question about the placement of this cylinder relative to the robot. I have read through the rules a couple of times, and couldnt find anything to answer my question. What I am wondering is if this cylinder has to be centered relative to the robot base (meaning you have only 42" in all directions to expand), or whether the only requirement is that your robot must fit inside an 84" diameter cylinder (meaning you could expand 84" on one side, but not the other. Any insight or clarification is greatly appreciated.
Thank you, Team 854 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Non-Cylindrical Bumpers? | Tomasz Bania | Technical Discussion | 1 | 04-02-2008 15:53 |
| Volume Accumulators | rsegrest | Rules/Strategy | 4 | 24-01-2008 14:49 |
| 80 inch diameter? | Pneumaticsman | Technical Discussion | 4 | 15-01-2008 08:54 |
| Going over 6 inch step with 12 inch wheels | Joe P | Technical Discussion | 25 | 12-04-2004 11:15 |
| Volume of tank + tube | blindguyinanorg | Pneumatics | 8 | 18-02-2004 00:32 |
Threaded Mode