|
|
|
 I don't think Dean Kamen ever recieved a real degree. That doesn't make him any less of an engineer.:) - Adam Y. [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't think Dean Kamen ever recieved a real degree. That doesn't make him any less of an engineer.:) - Adam Y. [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Is this possible in LabView?(Setting Pressure)
Coding is only one part of this task to consider. You have to find a way to actually provide the different pressures to the cylinder before you know how to program it.
See this thread for some possible ideas 
|
|
#2
11-01-2010, 22:37
|
||||
|
||||
|
Re: Is this possible in LabView?(Setting Pressure)
Thanks for the speedy response! I will look into the thread.
|
|
#3
12-01-2010, 14:53
|
|||
|
|||
|
Re: Is this possible in LabView?(Setting Pressure)
For controlling the pressure I would just use the joystick buttons. There is a VI in Labview that you can use to easily access the buttons on the joysticks.
As for the pressure what about limiting the flow of air rather than limiting the pressure. You could use 3 different orifices (think washers with different sized holes) on 3 different valves.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| POSSIBLE LABVIEW BUG | EncodersRUS | NI LabVIEW | 1 | 11-01-2010 23:22 |
| Does the Norgren Pressure Regulator show working pressure or stored pressure? | Madison | Pneumatics | 7 | 14-02-2008 17:40 |
| Is this possible? (Gears and chains) | TJ4nier | Technical Discussion | 7 | 20-01-2007 23:06 |
| Is this possible? | WhiteTiger | Control System | 2 | 08-02-2005 16:53 |
| TI Pressure Sensor this year? | kmcclary | Pneumatics | 1 | 20-01-2005 20:53 |
Hybrid Mode
