|
|
|
 I predict the champion drive teams at each event of the 2011 season will consist of vertebrates. - Taylor [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I predict the champion drive teams at each event of the 2011 season will consist of vertebrates. - Taylor [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Ramps
Our team was wondering about the dimensions of the ramp. The rules say it's 12 inches high and 12 inches wide on the top, but what is the length on the bottom? As well as the angle of the sides of the ramp?
|
|
#3
12-01-2010, 18:00
|
|||
|
|||
|
Re: Ramps
The bump is 36 in long in all. The two ramps are each 12 in long, and the top is another 12 in. Since the height is 12 in, this makes the angle 45 degrees. Good luck!
|
|
#4
12-01-2010, 18:01
|
||||
|
||||
|
Re: Ramps
The field drawings are found on the FIRST website with the manual. The specific PDF that outlines the bump is GE-10047.
The cross-section of the bump is 36" at the bottom, 12" tall, and 12" wide. Last edited by Taylor : 12-01-2010 at 18:15. |
|
#5
12-01-2010, 18:01
|
||||
|
||||
|
Re: Ramps
length of the bottom is 3 feet and as it was said before read manual and check drawings
|
|
#6
12-01-2010, 18:08
|
||||
|
||||
|
Re: Ramps
Okay, thank you.
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Ramps in action 2. | hiimcristhian | Extra Discussion | 3 | 20-02-2007 13:04 |
| Reverse Ramps??????? | cardinalman86 | Programming | 3 | 18-02-2007 18:25 |
| Robots with Ramps | UlTiMaTeP | General Forum | 6 | 17-02-2007 19:33 |
| Ramps ideas | Andrew Schuetze | Technical Discussion | 2 | 14-01-2007 01:20 |
| Gate Ramps | KWB@FIRST | General Forum | 14 | 17-10-2006 23:38 |
Linear Mode
