|
|
|
 My sister's husband told me when I was just a wee one, "momentum will take you where traction will not." - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| My sister's husband told me when I was just a wee one, "momentum will take you where traction will not." - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Problem with Default Program/Deploy
This was posted over in electrical, but I am having the same problem and hoping anyone in here might have some insight
"I have been trying for two days to get the default program to work on our test bot. I have been able to update the classmate both driverstation and labview. I have been able to format the crio both wirelessly and through crossover cable connection. Labview acts as if the program is deploying yet nothing happend on the bot all lights 2 jaguars and green on sidecar, remain flashing. The drivers tation program says no code in the status screen. I have tried running the program in labview instead of deploy both with the run on right click and the arrow. Nothing seems to be effective. Any suggestions would be very welcome." 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help to Deploy a Program in Labview. | Delian | NI LabVIEW | 7 | 10-12-2008 21:13 |
| PWM Problem with Default Code | kbregler | Programming | 16 | 03-02-2007 15:14 |
| Problem with program uploading | 1573 | Programming | 49 | 28-01-2007 13:51 |
| problem with the default code | MarkVH | Programming | 7 | 28-01-2005 00:04 |
| Problem with FRC Default code | AsimC | Programming | 2 | 11-01-2004 19:22 |
Threaded Mode