|
|
|
 That inspector needs their hard drive wiped and the common sense upgraded from version dingbat 1.0. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| That inspector needs their hard drive wiped and the common sense upgraded from version dingbat 1.0. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Motor curve spreadsheet
Last year I came across an Excel spreadsheet that contained the motor curves for several of the FRC motors. You could pick a motor and it would show the power and torque curves and allow you to enter some values for which it would calculate where they fell on the curve.
Can anyone point me at this - I can no longer find it. Many thanks, Steve |
|
#2
14-01-2010, 10:36
|
|||
|
|||
|
Re: Motor curve spreadsheet
|
|
#3
14-01-2010, 23:25
|
|||
|
|||
|
Re: Motor curve spreadsheet
That was the one, many thanks
|
|
#4
18-01-2010, 11:19
|
||||
|
||||
|
Re: Motor curve spreadsheet
Updated for 2010 at http://www.chiefdelphi.com/media/papers/2320?
|
|
#5
18-01-2010, 12:56
|
|||
|
|||
Re: Motor curve spreadsheet
Thanks Mark for posting this. I was looking for this info this morning, but couldn't find it. Are there torque curves available for the other kit motors as well?
 |
|
#6
18-01-2010, 14:07
|
||||
|
||||
|
Re: Motor curve spreadsheet
If you pull down in cell B13 there is a list of this years kit motors. Pick one and the plot should update. There are cell comments that provides additional instructions.
|
|
#9
18-01-2010, 20:50
|
||||
|
||||
|
Re: Motor curve spreadsheet
You might have been using my workbook. It also has a slider bar to change the settings and a gear ratio calculator. I deleted the old white paper as I updated the workbook and added an accompanying presentation. You'll find the new files here...
http://www.chiefdelphi.com/media/papers/2292 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| torque curve | LIL_C | Technical Discussion | 0 | 12-01-2008 14:02 |
| Need Wiper Motor Performance Curve | sanddrag | Motors | 2 | 07-11-2007 02:52 |
| Acceleration Curve | EricWilliams | Programming | 5 | 01-02-2006 16:27 |
| Drill motor torque curve | thedillybar | Motors | 1 | 10-03-2002 05:19 |
| Motor Calculation Spreadsheet | MrB | Motors | 0 | 16-02-2002 07:14 |
Why is there never enough time to do it right, but always enough time to do it again!
Linear Mode
