|
|
|
 (The wheels) need to be green anodized, and then assembled with yellow anodized spinners. ... and then, on the spinners, you can etch "JVN is a dweeb". That would be cool. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
14-01-2010, 08:17
|
||||
|
||||
|
Re: Possible to Adjust Speed
There are a few threads on this already, but we are thinking about using a servo attached to one (both?) of the flow control valves on a piston. Not ideal I know, but it won't require many parts.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drive Control, Wheel Speed Calibration, and Rapid Speed Changes | 7-11number1 | Programming | 3 | 23-01-2008 20:36 |
| Is it legal to adjust CIM's timming? | Capt. Quirk | Motors | 6 | 16-01-2008 07:35 |
| Wheel Speed Sensors / Vehicle Speed Sensors | chitu | Technical Discussion | 11 | 12-01-2008 02:46 |
| Possible to do multi-speed transmission with v-belt? | Squirrelrock | Motors | 15 | 13-12-2005 14:44 |
| speed controller max speed | Team 668 | Programming | 15 | 13-02-2005 14:05 |
Threaded Mode