2010 Camera and vision problems.

[Kingofl337]

With Java, it pretty much went.
Download: http://joule.ni.com/nidu/cds/view/p/lang/en/id/1534 and install it
Update cRio Image to v19 (Tick Format Controller)
Plug Camera into Laptop and Run Config Utility
Plug the camera into the robot using Port 2 and a Crossover Cable
Pull down the Netbeans plug-ins
Run the source code I posted on the last page

I'd assume it would be the same for Wind River, except you would need to download the update from http://first.wpi.edu/Images/CMS/Firs...te20100107.exe for Workbench.

[DanDon]

Originally Posted by Kingofl337

With Java, it pretty much went.
Download: http://joule.ni.com/nidu/cds/view/p/lang/en/id/1534 and install it
Update cRio Image to v19 (Tick Format Controller)
Plug Camera into Laptop and Run Config Utility
Plug the camera into the robot using Port 2 and a Crossover Cable
Pull down the Netbeans plug-ins
Run the source code I posted on the last page

I'd assume it would be the same for Wind River, except you would need to download the update from http://first.wpi.edu/Images/CMS/Firs...te20100107.exe for Workbench.

Hmm, only difference between your list and mine is that I manually edited the username and password rather than use the Config Utility. Does the Config Utility change anything else on the camera? I'll give running that a shot once I get into the lab and post results.

[Kingofl337]

Something else you may want to try, if you used Wind River last year is to uninstall it and delete all traces of it. Then reinstall, I think the location of WPILib.a moved down a directory and Wind River could be pointing to the wrong file.

You may also try searching for WPILib.a under C:\Windriver and deleting it, after that reinstall the Workbench update. If it can't find WPILib.a then that's your issue and you need to point to the current location. If you were using WPILIb source code to compile you WPILib.a file that can cause the issue as well. I haven't seen the new version of WPILib source yet.