|
|
|
 I believe that those who have a clear understanding of their capabilities, both physical and financial, and design and build within those capabilities are the teams that succeed. - Daniel_LaFleur [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[FTC]: How to run servos with LABview?
Using an FTC Tetrix Kit to build our robot, then program it with LABview we were able to run our motors. Now the problem is that when we try to modify the VI's to run our servos that control the rest of our automated parts of the robot, we are unable to make them move. The only movement we have seen them make was a twitch when we plugged them in so we know the connection is there and the servos are working. We have tried switching our daisy chain with the motors around, but to no avail. We tried motor configuring a few times and we have yet to see any improvement. Any suggestions?
Here's a (badly-editted) picture of our VI from imageshack: http://img18.imageshack.us/img18/6198/firsttech.jpg 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Labview - Servos | crollison | FIRST Tech Challenge | 2 | 13-11-2009 10:38 |
| [FTC]: Bluetooth Problem with LabView/FTC Controller Station | James Dowd | FIRST Tech Challenge | 8 | 27-10-2009 10:40 |
| [FTC]: Tips page on using FTC Encoders with LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 27-01-2009 14:00 |
| [FTC]: [FTC]: Can any one explain to me just how powerful the servos are? | sullivan_owns | FIRST Tech Challenge | 19 | 02-12-2008 16:06 |
| [FTC]: First problem with FTC and LabView.....? | PhilBot | FIRST Tech Challenge | 5 | 07-11-2008 10:36 |
Linear Mode
