|
|
|
 Place a corner of it on the end of a table, clamp down the other side, and have a good whack at it with a hammer (hard). If it didn't break, it was polycarbonate. - vivek16 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
cRIO Firmware Update?
We are trying to run code from the 2010 Classmate on the cRIO, but we are getting the error that the cRIO has different software installed, has there been a firmware update, and if so, where would we be able to get it?
Here is the exact error message: Access denied: This target is running a version of LabVIEW Real-Time that is different than the Real-Time Module software on the host computer. You can verify the version and reinstall the Real-Time software using Measurement & Automation Explore. Last edited by Sauce : 14-01-2010 at 18:03. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driver station firmware update | tanguma26 | Programming | 1 | 14-02-2009 19:53 |
| driver station and cRIO firmware update help | asianfez123 | FRC Control System | 1 | 16-01-2009 02:34 |
| Do we have to update firmware? | Emily M. | FRC Control System | 7 | 09-01-2009 18:34 |
| updating firmware on crio | nickmagus | Programming | 16 | 17-12-2008 16:58 |
| Firmware update | Cuog | Programming | 2 | 21-02-2006 20:28 |
Threaded Mode