|
|
|
 every year presents new challenges. What worked well last year might well be a clunker-bot this year. keep an open mind! - KenWittlief [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| every year presents new challenges. What worked well last year might well be a clunker-bot this year. keep an open mind! - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
15-01-2010, 10:44
|
|||
|
|||
|
Re: Tips for C++ programming the 2010 control system
I think the classmate sets itself to 10.xx.yy.5 when you go into the Driver Station account. You should probably leave it that when even if you are using for development.
If you use a separate laptop for development, you can set it to 10.xx.yy.6 Make sure your dashboard is actually updated as per my previous message (right before yours). You should see a compass type angle readout in the bottom-right corner. If you don't have this then your Dashboard is not updated properly and you will have to uninstall it and then reinstall it using DSUpdate1.0for2010.zip - Kevin Last edited by woodk : 15-01-2010 at 10:47. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2010 Control System Manual | screamingeagle | FRC Control System | 9 | 11-01-2010 14:01 |
| Unclaassified: Information about the 2010 control system | Nadav Zingerman | General Forum | 35 | 24-11-2009 19:17 |
| 2009 Control System LabVIEW Tips and Pitfalls | Travis Hoffman | NI LabVIEW | 3 | 22-12-2008 11:25 |
| 2009 Control System C++ Tips & Pitfalls | heydowns | Programming | 1 | 19-12-2008 17:59 |
| A few questions on programming the Control System | Avarik | Control System | 21 | 08-02-2004 11:42 |
Threaded Mode