|
|
|
 Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Did you know that if a G7, G27, G28, and G20 occur in that order at the same time, then the referee will appear to be doing the "YMCA"? :) - Jack Jones [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Power to cRIO
Hi,
We are having trouble getting power to our cRIO, we have it so the power goes to the power distribution board, but the power doesn't get to the connector that you use to power up the cRIO. We have used a multi-meter, so we know that the only spot where we aren't getting power is at the connectors at the end of the board where the battery does NOT connect to. Are we missing something??? We have looked at the documentation, but there we can't find the answer to our problem. Any help? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using a bench power supply for cRIO | Shinigami2057 | Electrical | 9 | 25-02-2009 13:13 |
| Power distribution board does not give power to access point | bitsoglass | NI LabVIEW | 3 | 17-02-2009 12:07 |
| Help! Connecting CRIO to the Power Block | RyanJK | Electrical | 3 | 07-01-2009 17:28 |
| Connecting Power Distribution block to cRio | Paul Rodi | Electrical | 2 | 05-01-2009 18:20 |
| 24v Power Conector to from the PDB to the cRIO | mcf747 | Electrical | 14 | 01-12-2008 19:19 |
Threaded Mode