|
|
|
 I always get a little stressed as arm operator, especially with Paul Copioli standing behind me screaming at me. - JohnnyB [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I always get a little stressed as arm operator, especially with Paul Copioli standing behind me screaming at me. - JohnnyB [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Gearbox Output Shaft Defect
Hi, I am from team 2974; we are a second year team.
In assembling our gearboxes, we stumbled across an issue pertaining to the gear shafts. One of the shafts had an input 1mm too wide in diameter but had a proper output size. On the other hand, the other shaft had the proper input diameter but the output diameter was off by approximately .05 mm. If anyone else encounters this error, let us know. We would like the community to be aware that faulty parts are afoot! -Nathan 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| roll pin into output shaft | m1k3 | Kit & Additional Hardware | 18 | 15-01-2008 16:18 |
| diameter of transmission output shaft | sj31419 | Electrical | 5 | 17-02-2005 22:09 |
| Cutting the output shaft | Kevin A | Technical Discussion | 2 | 18-02-2003 01:47 |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
Threaded Mode