|
|
|
 Put on shows. Start new teams, FRC, FVC, or FLL. It doesn't matter. But I know that being on the robotics team has given me some of the best memories of my life, and I wouldn't want anybody else to miss out on that. - irishninja [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
cRIO communications problem
Our driver station is completely unable to communicate with the cRIO. Until this morning, the cRIO imaging software was unable to find it, but the Driver account knew it was there. Now the Driver account can't find it either. We checked the wiring, and all we can think of is that someone accidentally shocked the cRIO, which we really hope is not the case.
|
|
#2
16-01-2010, 19:35
|
|||||
|
|||||
|
Re: cRIO communications problem
Is the power light on the cRIO on?
Are the cRIO Ethernet port 1 status lights blinking? Is the Robot Status Light on the Digital Sidecar on?
|
|
#3
16-01-2010, 19:52
|
|||
|
|||
|
Re: cRIO communications problem
Yes to the first two; apparently we haven't attached the robot status light yet though. Either that, or the electronics head didn't understand my question about where it was.
|
|
#4
16-01-2010, 19:57
|
|||||
|
|||||
|
Re: cRIO communications problem
The cRIO is probably fine then. It's a pretty tough system.
The robot status light is actually built-in to the Digital Sidecar. We attach the big separate robot status light to the Digital Sidecar, and right where it gets attached is an LED that blinks and lights up just as the big light will when you do finally attach it. The big light just makes it easier for you and the Field crew to see. It should be a blinking LED.
|
|
#6
16-01-2010, 20:22
|
|||||
|
|||||
|
Re: cRIO communications problem
Good catch. That is hard to notice.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem Configuring cRIO | shoffing | FRC Control System | 5 | 17-02-2009 08:29 |
| cRio corruption/polling problem | nathanww | Technical Discussion | 1 | 04-02-2009 23:24 |
| DS and cRIO Not Maintaining Communications | Will_Sica | FRC Control System | 0 | 10-01-2009 13:39 |
| cRIO Problem | Pneumaticsman | NI LabVIEW | 8 | 10-01-2009 11:59 |
| cRIO plugin problem | gabrielse | National Instruments LabVIEW and Data Acquisition | 3 | 18-12-2008 11:30 |
Hybrid Mode
