cRIO HELP!!!

mcristina444 · #1 01-16-2010, 03:16 PM

My team is not a rookie team so we have the cRIO from lat year. we decided not to use the classmate from devolpment. So we installed labview to a separate computer.we try to connect to the cRIO through the imaging tool but it can never find it. we have tried both crossover cables and straight cables but each time it can not find it. Any one elese have this problem?

Greg McKaskle · #2 01-16-2010, 05:33 PM

Be sure to turn off firewalls and disable any other networking interfaces such as wifi.

Greg McKaskle

alex42 · #3 01-16-2010, 05:41 PM

We're having the same problem. If I find a solution, I'll tell you.

alex42 · #4 01-16-2010, 08:02 PM

Also make sure that the cRIO isn't in safe mode. In that case, the DS won't be able to find it.

DanDon · #5 01-16-2010, 08:09 PM

Just a thought....make sure your computer's IP address is set up to

Code:

10.XX.YY.ZZ

where XX and YY are a four digit team number (with a leading zero if necessary) and ZZ is any unused address on the network.

jhersh · #6 01-17-2010, 04:51 AM

Also make sure you don't have any other network interfaces such as wireless adapters enabled.

aeasson · #7 01-17-2010, 02:28 PM

Be sure to check firewall status.
I had the probem you are describing and had to turn off the windows firewall.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Crio Help	GillSt.Bernards	FRC Control System	1	02-15-2009 12:00 AM
Need help with CRIO	GillSt.Bernards	Electrical	4	02-14-2009 02:42 PM
CRIO HELP!!!	lordsoze	Technical Discussion	8	02-07-2009 08:48 AM
Dead cRIO??!!? HELP!!!	naruto137	Technical Discussion	11	02-05-2009 11:58 PM
cRio IP change help	mastergamer1231	Programming	1	02-03-2009 07:38 PM