|
|
|
 The difference between a Tinkerer and an Engineer is that the Engineer will be able to tell you the results before you start. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The difference between a Tinkerer and an Engineer is that the Engineer will be able to tell you the results before you start. - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
17-01-2010, 15:01
|
|||||
|
|||||
|
Re: Need some help with possision of the ball.
Quote:
The FRAME PERIMETER is the area defined by the outside corners of your robot. The ball can't go more than 3 inches inside your FRAME PERIMETER. So you don't want a 12" deep notch in your robot frame below the BUMPER ZONE (that is, the bottom 10 inches of your robot) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I need some help with programming the Pneumatics | DPTeam270Driver | Pneumatics | 1 | 01-05-2008 18:58 |
| Hi, I need some help with the MPLAB IDE... | razer | Programming | 9 | 04-01-2007 07:47 |
| Need some help with a ball launcher | amateurrobotguy | General Forum | 5 | 05-02-2006 21:04 |
| need some help with the OI, and wiring a display | pryoplasm | Control System | 8 | 10-03-2004 20:46 |
| hey need some help with writing a code please help me here | magical hands | Programming | 9 | 01-01-2004 21:46 |
Threaded Mode