C-RIO there then not there

[bladetech932]

Ok I have looked extensively over the past few days and have not found anything related so i was hoping someone could help here is our problem
I am in programing and electrical and was getting ready to run the robot after following the "benchtop" test and i started up the computer and as always the d.s. account came up.
On the status lights the stop button and the communication are green but the Robot code is not (as expected since i have not built a code on yet). I switched
the account over to developer and made a code then proceeded to build it and Run as startup (i'm using labview by the way) but at the end of the Run as startup it stops to tell me that the C-RIO is not connected so i went back to the ds account and it still says that the C-RIO is still connected

Does anyone have any suggestions on what to check for this problem?
P.S. i have run the controls before it was on a robot and it worked fine.