|
|
|
 If you are content with where you are, you have celebrated the right things. If not, perhaps it is time to reconsider... what’s most important to you. - StephLee [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you are content with where you are, you have celebrated the right things. If not, perhaps it is time to reconsider... what’s most important to you. - StephLee [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
17-01-2010, 23:22
|
||||
|
||||
|
Re: Cypress board
I would probably try making a DLL file in C and including it on the LabView code. Make the DLL file so that it includes conversion and detection systems so that it can pick up the board and be able to understand it's output.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cypress FirstTouch hex file? | chronon | FRC Control System | 6 | 08-02-2010 12:29 |
| Cypress Board Configuration | Geek 2.0 | FRC Control System | 12 | 17-01-2010 04:23 |
| Cypress IO board connect | SteveD | FRC Control System | 12 | 16-01-2010 16:46 |
| Cypress Programmable System-On-Chip Solution? | 1jbinder | Electrical | 5 | 12-01-2010 22:13 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode