Cypress board LAYOUT - Chief Delphi

18-01-2010, 14:01

SteveD

Registered User

FRC #0888

Join Date: Jan 2010

Location: Glenelg, MD

Posts: 21

SteveD is an unknown quantity at this point

Cypress board LAYOUT

Hi, i have spent an hour looking through posts on chief delphi and have been unable to find detailed instructions on using the cypress board. we configured it and can connect to it fine, but we cant figure out how to use it. I took a switch that was wired from last year (with a pwm cable and a resistor on the red wire), and connected the black to ground, red to the top, and the white to P4_5. what do we do from there? we would like for this switch to control Digital Input 1. THANKS for any help

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cypress Board Issues	kgzak	FRC Control System	4	02-02-2010 18:40
Cypress Layout (over wires?)	flameout	FRC Control System	18	23-01-2010 18:09
Cypress board	bls0620	Electrical	4	17-01-2010 23:22
Cypress Board Configuration	Geek 2.0	FRC Control System	12	17-01-2010 04:23
Cypress IO board connect	SteveD	FRC Control System	12	16-01-2010 16:46

All times are GMT -5. The time now is 23:26.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.