|
|
|
 It is an honor and a privilege to be associated with such an outstanding group of people. And Arefin. - Gary Dillard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It is an honor and a privilege to be associated with such an outstanding group of people. And Arefin. - Gary Dillard [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Bevel Gears...
Hello all,
I have some problems using the design accelerator... I want to create a bevel gear with 16 teeth to 16 teeth, module 1.5 and face width of 5.5 mm (about 0.22 in)... The program "claims" that the calculation indicates about a design failure... And it's not true - i have this gear in my hand... What should I do?? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help: Bevel Gear Mounted On CIM Shaft? | 854 bears | Motors | 16 | 24-07-2009 13:50 |
| Replacement for Bevel Gears? | Greg | Technical Discussion | 3 | 30-03-2003 19:56 |
| Bevel Gears on Drivetrain | archiver | 2001 | 7 | 23-06-2002 22:57 |
| 45 Bevel Gears | Ryan Curry | Technical Discussion | 1 | 03-04-2002 09:36 |
Threaded Mode