|
|
|
 There's nothing that you can do to please everyone. You have to figure out where you stand and hold your ground. - sciguy125 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There's nothing that you can do to please everyone. You have to figure out where you stand and hold your ground. - sciguy125 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
18-01-2010, 16:09
|
|||
|
|||
|
Re: Bevel Gears...
I don't know the real way to get around it but after some experimentation with the design accelerator i found that if you mess with the input values enough in the calculations section it will eventually accept the design. Or i you don't have the time just say ok to the warning and it will create the bevel gears anyways.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help: Bevel Gear Mounted On CIM Shaft? | 854 bears | Motors | 16 | 24-07-2009 13:50 |
| Replacement for Bevel Gears? | Greg | Technical Discussion | 3 | 30-03-2003 19:56 |
| Bevel Gears on Drivetrain | archiver | 2001 | 7 | 23-06-2002 22:57 |
| 45 Bevel Gears | Ryan Curry | Technical Discussion | 1 | 03-04-2002 09:36 |
Threaded Mode