|
|
|
 If all you have to say are demeaning and vile comments, then shut your trap and keep it to yourself. - Ryan Dognaux [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If all you have to say are demeaning and vile comments, then shut your trap and keep it to yourself. - Ryan Dognaux [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
18-01-2010, 18:48
|
|||
|
|||
|
Re: Steel Frame
We have a prototype steel frame. 1x1x16ga.
No test data yet. Check out Wellnuts for attaching things. http://www.hansonrivet.com/w71.htm We are also using a Flowdrill for tapped holes. My 1.5hp bridgeport will work a 10-32 flowdrill, if I spot heat with a torch just before drilling. To get equal durability from aluminum we would have had to heat treat after all the welding. Didn't seem practical. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steel Frame? | gburlison | Technical Discussion | 20 | 18-12-2007 16:56 |
| Welding stainless steel to mild steel... can it be done? | Travis Covington | Technical Discussion | 3 | 27-01-2004 19:11 |
| Steel Blends | Wetzel | Technical Discussion | 2 | 15-09-2003 17:01 |
| steel tubing | BBFIRSTCHICK | Rules/Strategy | 2 | 14-01-2003 22:03 |
| Steel Edge | AJ Howard | Rules/Strategy | 1 | 18-01-2002 18:52 |
Threaded Mode