|
|
|
 Basically, just because you CAN do something doesn't mean you should and being savvy enough doesn't entitle you to being above the law. - Greg Needel [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Basically, just because you CAN do something doesn't mean you should and being savvy enough doesn't entitle you to being above the law. - Greg Needel [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Got error at deploy
I cant deploy my projectto cRIO controller.
When i tried to deploy its send an error massage that the cRIO doesnt has the same software like my classmate, or something same. What can I do to solve this problem. thx 
|
|
#2
20-01-2010, 08:38
|
|||||
|
|||||
|
Re: Got error at deploy
Make sure your Classmate has the latest LabVIEW update installed.
See the Control System page for the link to "Mandatory LabVIEW Update" Then use the FRC cRIO Imaging Tool to download the latest cRIO firmware (v19) that comes with that update. The Classmate and the cRIO must be at the same revision level. Last edited by Mark McLeod : 20-01-2010 at 11:40. Reason: Fixed it - thanks Joe
|
|
#3
20-01-2010, 11:41
|
|||||
|
|||||
|
Re: Got error at deploy
Opps, Unintentional typo.
Thanks Joe
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Deploy NOT Download | bladetech932 | Control System | 3 | 19-01-2010 22:04 |
| I can't build or deploy! Error 6? | grosh | NI LabVIEW | 8 | 28-02-2009 10:54 |
| unable to deploy | SL8 | NI LabVIEW | 1 | 17-02-2009 21:02 |
| Help to Deploy a Program in Labview. | Delian | NI LabVIEW | 7 | 10-12-2008 21:13 |
| 97's Ramp Deploy | ZZII 527 | Robot Showcase | 5 | 28-02-2007 15:18 |
Linear Mode
