Deploy doesn't work - Chief Delphi

20-01-2010, 14:07

Haragorn

Registered User

FRC #0888

Join Date: Jan 2009

Location: MD

Posts: 6

Haragorn is an unknown quantity at this point

Deploy doesn't work

Our control system has been working fine for a while. However, today, I made some small changes to the code, built it, and deployed it through the Classmate. This has always worked before. However, when I went into Driver mode, the Driver Station said there was no code. I rebuilt and redeployed the code, and it still didn't work. I also tried building and deploying the default code, with no luck. Any ideas what to do?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RSL Doesn't work	BKmike	FRC Control System	4	16-02-2009 12:01
Run works but build&deploy doesn't	program1	NI LabVIEW	3	03-02-2009 22:32
LCD Doesn't work :(	magical hands	Programming	6	08-03-2007 20:37
sensor doesn't work	PBoss	Programming	7	29-01-2003 18:39

All times are GMT -5. The time now is 15:22.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.