|
|
|
 But I suppose friendly reminders to read the manual are much better than sarcastic ones. - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| But I suppose friendly reminders to read the manual are much better than sarcastic ones. - dtengineering [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
20-01-2010, 17:39
|
||||
|
||||
|
Re: paper: CG Migration of Robot Crossing Bump using Powerpoint
For those that are wonder where their CG will end up, take a look at http://www.chiefdelphi.com/media/papers/2048
It allows both weight budgeting and CG estimation. You can use this to get an estimate before the CAD modeling gets too far along. 10-20 minutes spent now on budgeting can save hours (or even days) of rework. I apologize that the user interface is not slicker and am open to suggestions for improvement. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Cost Effective Robotics: Using Vex in FRC | artdutra04 | Extra Discussion | 2 | 09-01-2006 01:47 |
| White Paper Discuss: Increasing A/D Resolution Using Noise | CD47-Bot | Extra Discussion | 7 | 12-10-2004 09:26 |
| White Paper Discuss: Using an Operator Interface with the 2004 EDU RC | CD47-Bot | Extra Discussion | 6 | 20-01-2004 21:11 |
Threaded Mode