Inventor 2010 Parts Kit complications

[wrenauld]

Your source for the KOP parts will make a difference with what you can do with the part files. If you got them from Andymark the are standard part files. If you got them from Autodesk most are part files that a relatively new feature called base solids. Basically this limits editing of standard parts. Example: Frame rails can only have their length change by moving a face while in the solid editor. I have not played with it much but this is what I found so far. I can see this being used in industry but is a little cumbersome for our team at this point. Hope this helps.

W.R. team 1922 OzRam

[joek]

it's because parts were placed from the content center
and on a side not: the chassis was assembled wrong

[inventor_phild]

Hi all,

I have had a couple of comments on the chassis. The intial posting on the autodesk.com\first site matched the original design prior to kick off. A design change has since been implemented. I have uploaded a new assembly file to match the assembly design change.

Any questions on this, please contact phil.dollan@autodesk.com

[Abole]

We've recently downloaded an update on content center after we had already downloaded the parts for inventor. It has brought in some new parts when i try briniging up some pieces, but hardly any though, maybe like 12 bolts on the chaisis.