NEW Forum for CAN

Mike Martus · #1 20-01-2010, 21:19

At the request of many Brandon has made a new forum under the electrical.

CAN

This will be an important sharing for this technology that is new to us.

Joe Ross · #2 20-01-2010, 21:35

If you want to see it in your portal, be sure to update your recent posts config.

EricVanWyk · #3 20-01-2010, 22:41

Is there a good reason to split it off of the regular electrical forum? I'd hesitate to do so, because as Joe said, folks won't see posts about CAN on the front page unless they configure it as such. Since this thread is likely to fall off the main page, it is likely that people won't know to do so.

Al Skierkiewicz · #4 21-01-2010, 11:14

Erik,
CAN discussions were showing up all over anyway. This is an attempt to get everything in one place. I will add a post in electrical to point there and anyone can remind other forums to post there as well. I think all will find it in a day or two.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FIRST EMAIL/New Q&A Forum for Championship Teams	Mark McLeod	FIRST E-Mail Blast Archive	0	11-04-2008 08:52
Seperate Forum/Sub forum for Demos?	Mark Pierce	CD Forum Support	2	20-09-2007 23:37
Can we change this forum?	WakeZero	OCCRA	9	15-10-2003 22:05
New Forum for 845!	Jonathan M.	Website Design/Showcase	2	27-02-2003 08:36
New forum for websites and design!	activemx	CD Forum Support	6	21-09-2002 12:07