|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
I am just wondering if there is a size restriction on the maximum size for the driver station.
If you have any insight on this, please help me. Thanks Ian Heffron Team 2811 Rules man ![]() |
|
#2
|
|||||
|
|||||
|
Re: Size limit for controller station?
Quote:
In this case, you want <R81>, which tells you that you have a 60" by 12" inch shelf that the console has to fit on. But wait, there's more! According to Section 6.2.10 , there is a 54" x 2" strip of loop-side Velcro tape running down the middle of that shelf. You are highly advised to have a matching hook-side strip on the bottom of your operator console. (I've seen control boards go flying before that strip of Velcro was added. Trust me, it's worth it.) |
|
#3
|
||||
|
||||
|
Re: Size limit for controller station?
Is there a maximum height restriction on the controller station?
|
|
#4
|
|||||
|
|||||
|
Re: Size limit for controller station?
Quote:
I would also highly discourage going higher than the top of the alliance station wall; there may be a few missed shots/trident hits up there. |
|
#5
|
||||
|
||||
|
Re: Size limit for controller station?
Hey Eric,
How do you write "...has read the 2010 manual" with your name and avatar at the top of all of your posts? Plus, how do you get a reputation? |
|
#6
|
|||||
|
|||||
|
Re: Size limit for controller station?
I'll PM you about that.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Controller size limit? | KGood | Technical Discussion | 5 | 09-02-2008 16:27 |
| Wire Size Limit? | (InsrtNameHere) | Electrical | 2 | 15-02-2006 20:20 |
| [OCCRA]: Size limit of Operator Control Station | Alex Golec | OCCRA Q&A | 1 | 11-10-2005 05:33 |
| Robot Controller File Size Limit ?? | RoboGeek | Programming | 1 | 17-01-2005 19:59 |
| Operator Station Size | ktrussell | Technical Discussion | 0 | 15-01-2003 15:57 |