|
|
|
 looks like he was getting ready for a sprint! be careful chuck, its only like 2 feet from the line to the controls... - vivek16 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| looks like he was getting ready for a sprint! be careful chuck, its only like 2 feet from the line to the controls... - vivek16 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Sensitivity of Cypress board
I recently wired a cypress board to a single switch. I have good communications and everything, however the board seems to be really sensitive. If i am holding the board, all of the inputs will constantly flash on-off. On the switch that i wired, when i switch off, the light stays off on the digital display. but when i turn it on, it will constantly flash. Is this normal. I assume its just due to my poor wiring job. Anything to reduce this sensitivity, other than rewiring with solid core wires?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cypress Board Issues | kgzak | FRC Control System | 4 | 02-02-2010 18:40 |
| Cypress board LAYOUT | SteveD | FRC Control System | 11 | 23-01-2010 11:23 |
| Cypress board | bls0620 | Electrical | 4 | 17-01-2010 23:22 |
| Cypress Board Configuration | Geek 2.0 | FRC Control System | 12 | 17-01-2010 04:23 |
| Cypress IO board connect | SteveD | FRC Control System | 12 | 16-01-2010 16:46 |
Threaded Mode