|
|
|
 You'll find that there are plenty of teams and individuals who shout. You'll also find there are a smaller subset of teams and individuals that do. Those that do tend to be the ones that get their way. - Lil' Lavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
25-01-2010, 20:33
|
||||
|
||||
|
Re: Reusing Models
Yes, it's possible to use old models. Try exporting them as a .fbx. If you're using 3ds Max 2010 it's under export. Then it should open right up in Maya.
|
|
#4
14-02-2010, 01:08
|
||||
|
||||
|
Re: Reusing Models
The only drawback to reusing models is that the students may not get a good grasp on good modeling and texturing. I discourage students reuse the models unless they made them the themselves because I feel its important that they understand good modeling techniques, but thats just me.
Good luck everyone.  |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reusing Lock Nuts | ManicMechanic | VEX | 1 | 13-09-2007 14:26 |
| reusing drive design | VEN | General Forum | 20 | 04-04-2006 03:35 |
| Reusing gearbox & bearings | BlacKnight6604 | Technical Discussion | 2 | 14-01-2004 21:49 |
| Reusing Old Gyros | Venkatesh | Programming | 4 | 14-01-2004 09:44 |
| Reusing Parts | Sachiel7 | Technical Discussion | 4 | 18-10-2003 10:51 |
Hybrid Mode
