|
|
|
 It made me proud to know that we have corporate sponsors with genuine interest. - galewind [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| It made me proud to know that we have corporate sponsors with genuine interest. - galewind [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
configure wireless router
i am trying to configure the wireless router,wrt160n, i am following the FRC 2010 control manual step by step, the bridge configures just fine, but when i get to page 52, the picture in the manual show the start IP address as 10.0.0.1, however mine shows the default 192.168.1.1 i cannot get it to change so i can put in my address for our team, likewise the ipaddress range is only the default.
please help 
|
|
#2
21-01-2010, 22:40
|
||||||
|
||||||
|
Re: configure wireless router
While I haven't configured a WRT160N, I believe if you put in the IP address on top, and set the start IP address to 10, when you save the settings and reboot, everything will be correct afterwards.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wireless Router to Connect with Driver Station | Happyisgood | FRC Control System | 15 | 04-09-2009 00:02 |
| Use of Wireless Router | Andrew Lindsay | Rules/Strategy | 3 | 12-01-2009 14:17 |
| Wireless Router Issues | zim2411 | Scouting | 17 | 09-04-2008 22:24 |
| Mcc-wrapper and configure.py back | HighLife | Programming | 0 | 29-01-2008 19:46 |
| Configure Portal 'Recent Activity' box. | Brandon Martus | Announcements | 18 | 19-07-2004 11:48 |
Linear Mode
