22-01-2010, 03:46
|
 |
Registered User
 FRC #2854 (EVHS Robotics) Team Role: Leadership
|
|
Join Date: Dec 2008
Rookie Year: 2009
Location: San Jose, CA
Posts: 32
|
|
|
Re: Axis Camera 206 Power Connection
From Chapter 3 of the 2009 Control System Manual:
Quote:
How do I build a cable for passing 5V power to the Ethernet camera?
• Take the camera’s power adapter (PN SA106A-0512-6) and cut the wire off close to the
Wall-Wart.
o Note: There are two power adapters for the camera included in the Kit, one in the
camera box and one separate. Use the separate one (PN SA106A-0512-6) to make
this adapter.
• Separate the wires and strip 5-6mm off the ends.
• Use a small flat head screwdriver to open the WAGO 739-302.
• Insert the positive (striped) wire in the right port. Note: the correct orientation can be verified
by looking at the silk screen on the PD Module.
• Insert the negative wire in the left port.
• Give a smart tug to verify the connection is secure.
• Power the PD, and verify that the barrel connector’s center conductor is positive
|
|
I think that in general people should worry more about what they are doing, and less about what others are doing. That goes for a lot more than FIRST. - pfreivald [more] 
Similar Threads
Threaded Mode