|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
Re: Restrainting pin question
It is not advisable to use the piston rod as a direct mechanism. It should operate a mechanism that will take the load instead.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RC +5V Pin Voltage | adam2177 | Electrical | 6 | 18-02-2008 13:07 |
| Tx/Rx pin layout? | EHaskins | FIRST Tech Challenge | 1 | 27-02-2006 10:18 |
| Pin Trading | Astronouth7303 | Chit-Chat | 12 | 14-05-2004 14:20 |
| Dutch Pin | patrickrd | Technical Discussion | 5 | 03-03-2002 12:27 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |