How do you wire the inputs for holonomic drive (omni wheels)

One must agree that a Bus full of FIRSTers is always Fun'n Frolic. :) - RoboMadi [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
How do you wire the inputs for holonomic drive (omni wheels)

22-01-2010, 22:29

kamocat

Test Engineer

AKA: Marshal Horn

FRC #3213 (Thunder Tech)

Team Role: Mentor

Join Date: May 2008

Rookie Year: 2008

Location: Tacoma

Posts: 894

Re: How do you wire the inputs for holonomic drive (omni wheels)

Well, you could use the Z axis.
Or you could use a handheld controller (eg logitech gamepad)

__________________
-- Marshal Horn

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do you wire up the Operator Interface?	iPilipino	Electrical	6	22-01-2008 00:22
How do you wire the wheel encoders?	Demothesis	Electrical	2	17-07-2007 16:59
Friction coefficients for Omni wheels and Mecanum wheels from AndyMark	Andy Baker	Technical Discussion	11	16-12-2006 19:40
Omni-wheels and driver-centric drive	efoote868	Programming	10	01-11-2006 22:22
How do you drive the KOP 6" wheels?	Alex Cormier	Technical Discussion	7	04-11-2004 17:14

All times are GMT -5. The time now is 04:18.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.