|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Can't retract to go under TUNNEL?
http://forums.usfirst.org/showthread.php?t=13940
This Q&A seems to outlaw a ROBOT whose upper extremities collapse into its lower ones for the purposes of going through the TUNNEL. I can't see any good reason for the GDC to say this, nor a particular rule that such a ROBOT would break? |
|
#2
|
|||||
|
|||||
|
Re: Can't retract to go under TUNNEL?
Quote:
|
|
#3
|
|||||
|
|||||
|
Re: Can't retract to go under TUNNEL?
You're about the third one to notice...
My interpretation is that 1) Jeff is right about the wording being unclear and 2) they're asking about expanding the frame perimeter, which is illegal, not pulling a lift system down within the frame perimeter, which is legal. |
|
#4
|
|||||
|
|||||
|
Re: Can't retract to go under TUNNEL?
My belief is that the GDC interpreted the question as extension and/or retraction in the length and width dimensions which is not allowed based on the definition of the NORMAL CONFIGURATION.
I see no rule that would prevent extension/retraction in the height dimension. Last edited by Vikesrock : 21-01-2010 at 17:08. Reason: Oops, totally forgot about <R11> |
|
#5
|
||||
|
||||
|
Re: Can't retract to go under TUNNEL?
I think the answer was given as "no" because during the teleoperated period the robot is not allowed to go into any other section of the field besides were it starts.
|
|
#6
|
|||||
|
|||||
|
Re: Can't retract to go under TUNNEL?
Quote:
When answering rules questions here on Chief Delphi it is always best to cite and/or quote the rule or definition that led you to your conclusion. |
|
#7
|
|||
|
|||
|
Re: Can't retract to go under TUNNEL?
...Really? Then why all the fuss about invertible robots and designing a "Shremech" as they used to be called on TV's Robot Wars (Self-Righting Mechanism) to right a tipped robot that failed going over the BUMP?
|
|
#8
|
||||
|
||||
|
Re: Can't retract to go under TUNNEL?
I think you mean during autonomous period, where the robot can't cross the middle line. In teleoperated, I'm pretty sure you can go wherever you want.
|
|
#9
|
||||
|
||||
|
Re: Can't retract to go under TUNNEL?
With one limitation - you can only have one of your alliances robot in the defensive zone at any given time.
|
|
#10
|
||||
|
||||
|
Re: Can't retract to go under TUNNEL?
Quote:
![]() |
|
#11
|
|||
|
|||
|
Re: Can't retract to go under TUNNEL?
<R10> During the MATCH, the ROBOT will assume one of two operating configurations. When in each configuration, the ROBOT shall fit within the limits of NORMAL CONFIGURATION or FINALE CONFIGURATION
I believe the definition of normal configuration is the reason for "NO" NORMAL CONFIGURATION – The physical configuration and orientation of the ROBOT when the MATCH is started. This is the state of the ROBOT immediately before being enabled by the Field Management System, before the ROBOT takes any actions, deploys any mechanisms, or moves away from the starting location. This configuration is static, and does not change during a single MATCH (although it may change from MATCH to MATCH). |
|
#12
|
|||
|
|||
|
Re: Can't retract to go under TUNNEL?
Thoughts? You start as a tall bot in auto. At end of auto you drive over, touch pole and shrink down to go through tunnel. At other end of tunnel you expand. Legal or not? I'm going to say yes as long as you never lose contact with tower parts. The amount of time you spend lowering and raising might not be worth it.
|
|
#13
|
|||
|
|||
|
Re: Can't retract to go under TUNNEL?
Seems somewhat plausible per <G30>
Starting small in zone 1 or 3 you can extend in zone 2 and cannot contract to go back under a tunnel. <G30> ROBOT Volume – During a MATCH, no part of the ROBOT shall extend outside the vertical projection of the FRAME PERIMETER, except as follows: c. TOWER Contact ROBOT Volume - During a MATCH, ROBOTS in contact with their ALLIANCE TOWER may extend beyond their NORMAL CONFIGURATION volume but may not exceed the FINALE CONFIGURATION maximum volume. |
|
#14
|
||||
|
||||
|
Re: Can't retract to go under TUNNEL?
true
|
|
#15
|
|||||
|
|||||
|
Re: Can't retract to go under TUNNEL?
Quote:
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tunnel Blockers??? | Team 2811 | Rules/Strategy | 10 | 23-01-2010 17:36 |
| Tunnel part of Tower | GaryVoshol | Rules/Strategy | 10 | 19-01-2010 13:20 |
| Tunnel Height | JamesByrne | General Forum | 3 | 11-01-2010 17:46 |
| pic: Wind tunnel | Pat Major | Extra Discussion | 20 | 19-02-2009 19:41 |
| Wind Tunnel | Wayne Doenges | General Forum | 48 | 21-01-2005 19:22 |