|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Contradicting Dimensions for Trident
New dimension question...
G6.2.4 from udate number 3 "The PLATFORM is approximately 41 inches wide by 32 inches deep, and is at a height of approximately 21 inches above the floor. A 36-inch wide by 18-inch tall TUNNEL under the PLATFORM, providing a passageway between the MIDFIELD and the adjacent end ZONES." Rev B Game Field Specs: Inside wall = 16 1/2 x 32 1/2 Upright stiffener = 17 x 3 1/2 SO we have built a platform to specs and prototyping team is complaining that platform is 1 inch too short...which is correct, the manual or the specs? |
|
#2
|
|||||
|
|||||
|
Re: Contradicting Dimensions for Trident
The drawings are the correct measurements:
Quote:
|
|
#3
|
||||
|
||||
|
Re: Contradicting Dimensions for Trident
when building the trident for our team, we used the 48" length and when we measured from end to end the length was as the size in the manual was, 6 feet. hope that helps
|
|
#4
|
||||
|
||||
|
Re: Contradicting Dimensions for Trident
And in contrast - we built our according to the drawing and they were 5 ft., which also matched with the size of the trident at kick-off in Manchester, but not with the manual.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Contradicting dimensions? | StorminNormin | General Forum | 30 | 22-01-2010 17:02 |
| Can trident break field boundary? | johnr | Rules/Strategy | 2 | 20-01-2010 09:34 |
| Trident Design | JJD | General Forum | 3 | 16-01-2010 14:38 |
| [OCCRA]: Looking for SPECIFIC Dimensions for the Game field! | stk86 | OCCRA Q&A | 1 | 28-09-2004 10:46 |
| Looking for SPECIFIC Dimensions for the Game field! | stk86 | Technical Discussion | 0 | 27-09-2004 15:21 |