|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Incremental encoder mounting
The included US digital 3p4 encoder fits a maximum .25 inch diameter shaft. However, we are not using the included kit-gearbox, and our shaft will be .5 inch diameter. Can anyone recommend encoders that can fit around a .5 inch shaft? Or, is down-stepping our shaft to .25 inches a good option?
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Encoder Mounting Pads - Drawings? | kmcclary | Kit & Additional Hardware | 5 | 07-02-2009 11:25 |
| Screwing Encoder into Encoder Mount? | Adrien | Electrical | 3 | 25-01-2009 18:14 |
| Mounting | m1k3 | Pneumatics | 1 | 28-01-2008 19:48 |
| Mounting encoder/cutting 12 in axel | intellec7 | FIRST Tech Challenge | 8 | 12-04-2006 12:55 |
| Drill mounting | Rickertsen2 | Motors | 9 | 27-01-2004 02:14 |