|
|
|
 We didn't need a championship to recognize the kids on our [little league] team and we sure didn't need one to inspire them. If you want to go to the championships then work harder, don't try and lessen the value of the championships by letting everyone in. - FarmerJohn [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Mounting Electronics
I don't know if this is the right section to post in but anyway...
I was wondering if there are any restrictions on how to mount electronics on a conductive surface i.e can we mount the electronics using a rubber insulator or shim instead of plexiglass? Any advice is appreciated. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is polycarbonate allowed for mounting electronics | eccmaster | Kit & Additional Hardware | 5 | 09-02-2008 23:22 |
| Mounting | m1k3 | Pneumatics | 1 | 28-01-2008 19:48 |
| Mounting encoders? | waialua359 | Technical Discussion | 4 | 13-02-2006 01:57 |
| mounting the electronics | greencactus3 | Electrical | 11 | 17-02-2004 07:39 |
| mounting electronics | nwagers | Electrical | 10 | 15-02-2002 13:09 |
Threaded Mode