|
|
|
 FIRST is a big family and we‘ll get through this together. - Gary Dillard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is a big family and we‘ll get through this together. - Gary Dillard [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-01-2010, 21:06
|
|||
|
|||
|
Re: Wiring Switches to the PSoC board
I don't think your robot will listen to the board in autonomus mode unless its on the robot.
Yes the PSoC is much like the blue box from last year. You have to load a hex file onto it. The file comes in the control station update. You can plug PWM pins directly to the I.O. pins on the board or use a carrier board. andymark has one for 22.00. If you plan to hook a laptop other than the control station to the PSoC you have to use the breadboard from the kit. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring The IR Board | joesmomh00haha | Sensors | 2 | 12-02-2008 15:30 |
| Wiring the IR sensor board | govvijay | Programming | 9 | 05-02-2008 19:41 |
| Need tips on wiring the IR board | Bryan Herbst | Control System | 4 | 12-01-2008 18:34 |
| Making switches that plug into the oi board | cdennisxlx2 | Control System | 2 | 12-02-2006 20:59 |
| Wiring Switches To the Operator Intrerface | archiver | 2000 | 2 | 23-06-2002 23:02 |
Threaded Mode