|
|
|
 Perhaps we should just have signs put up that say "Please remove your head and tail before entering". - Molten [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Perhaps we should just have signs put up that say "Please remove your head and tail before entering". - Molten [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Black jaguars: not working
As a side thought, is your CAN bus properly terminated? To make the CAN bus work it is my understanding that you need approximately a 100ohm resistor joining CANH and CANL on the last Jaguar. The pin outs can be found in the data sheet available here: http://www.luminarymicro.com/products/mdl-bdc24.html. I don't know if this will fix the problem but it may be something in the right direction.
-Ian Programmer, Team 2022 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Serial to CAN Gateway in new Black Jaguars? | dmcguire3006 | Electrical | 54 | 26-01-2010 07:32 |
| Jaguars arent working | yoavh360 | Electrical | 6 | 19-01-2010 17:20 |
| Victors and Jaguars not Receiving Signal? | excel2474 | Electrical | 1 | 12-02-2009 16:41 |
| jaguars suddenly not working | Mr. E | Technical Discussion | 1 | 07-02-2009 21:09 |
| Jaguars working with 2.4 Ghz R/C | NOV8R | Technical Discussion | 0 | 09-01-2009 16:15 |
Hybrid Mode
