|
|
|
 I tried, but our freshmen lost enthusiasm about filing the blocks of aluminum I gave them into Andymark Performance Wheels after only a few hours! - Greg Woelki [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#7
01-24-2010, 03:59 PM
|
|||
|
|||
|
Re: Need to manually reboot cRIO to download code
Our team was having the exact same problem!
Now, everytime we re-download code to the robot, we make sure we have the Driver Station opened in the Developer account, close out of it, then click run. Once Netbeans goes through all its stuff, reboots cRIO, etc. It will get to the line DisableInit() completed. From there you can re-open the FRC Driver Station and everything should work perfectly. Hopefully this bug of ghost code is fixed! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Download from Crio to Labview | MachineSMMC | NI LabVIEW | 3 | 10-16-2009 01:37 PM |
| Cannot get Code to Download to cRIO | greekgod8591 | C/C++ | 25 | 03-09-2009 10:10 PM |
| Crio image download | brainsdmaner | FRC Control System | 2 | 02-15-2009 01:06 AM |
| Reboot robot every download? | lostkhaos | NI LabVIEW | 16 | 02-13-2009 02:35 PM |
| cRIO loses code on reboot? | boris | FRC Control System | 1 | 01-30-2009 10:42 AM |
Threaded Mode