|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
Re: Help with reconnecting with DS
Max, full name National Instrument Measurement and Automation Explorer, should have been installed on any computer that had LabVIEW installed, and probably WindRiver and Java.
The first thing to do is to simplify the networking. Ideally, just one computer, a cable, and the cRIO. Be sure to turn off the firewall, run Max and see refresh the remote devices. If the controller shows up, you can reconfigure it to have your teams number. If that doesn't work, it will likely be necessary to use the DIP switches to reset the IP and use the imaging tool. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| help with IE | eternalearth888 | Website Design/Showcase | 3 | 25-02-2009 00:49 |
| Dean's Homework: Reconnecting with FIRST Alumini | neoshaakti | General Forum | 4 | 04-01-2009 17:59 |
| HELP!!! STUCK WITH SUB ROUTINES WITH THE IR!!! | drewjones13 | Programming | 1 | 17-01-2008 20:52 |
| hey need some help with writing a code please help me here | magical hands | Programming | 9 | 01-01-2004 21:46 |
| Problem with communicating with STAMP through serial port | Skabana159 | Technical Discussion | 2 | 06-02-2003 21:10 |