Labview Programming Help

[Technic-R-C]

Hey,

I have a question for you guys.

When I load labview and attempt to run the sample 2010 Breakaway FRC template code (with a bit of modifitactions - added compressor VI and Relay VI's in the teleop code) the code does NOT enter execute mode (stays in init mode). I tried to counter this my making the teleop case structure set to execute through a constant but that gave out errors...) When I build the project and deploy/run as startup and then switch to driver station mode the code does not work...

Quick Clarification: I can't seem to find the experimental framework.. did they remove it?

When I try to run regular sample VI's the code seems to be running (using lightbulb debug) but the cRIO does not respond to the commands... I am really frustrated and would appreciate your guys input.

I have formatted the cRIO but I think I might as well do it again. I don't have the camera connected while running the code so this might be causing the teleop mode "init" hangup

Thank you and best regards,

Technic-R-C