|
|
|
 The weight sounds about right, too. If you need more than 65 pounds for your manipulator, then the drivetrain isn't the part you should be redesigning... - s_forbes [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The weight sounds about right, too. If you need more than 65 pounds for your manipulator, then the drivetrain isn't the part you should be redesigning... - s_forbes [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
cRIO and Laptop Not Communicating ERROR CODE 63
We have hooked up everything, and we did a Ethernet connection from the cRIO to the laptop. When we go to the the FRC driver station and press enable, the words "No Robot Communication" flash red.
Any help at all is appreciated. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver's Station not communicating with cRio | Alexandstein | Technical Discussion | 8 | 21-01-2010 21:05 |
| cRIO Not Running Code?!? | JohnFogarty | Programming | 11 | 17-01-2010 19:08 |
| Communicating with a laptop | BEEKMAN | C/C++ | 16 | 09-01-2010 21:08 |
| Laptop is not finding the cRIO properly? | Studentish | Electrical | 4 | 07-05-2009 12:03 |
Threaded Mode