|
|
|
 Please don't confuse energetic enthusaism with acting obnoxious. - Alan Anderson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Please don't confuse energetic enthusaism with acting obnoxious. - Alan Anderson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
25-01-2010, 21:31
|
|||||
|
|||||
|
Re: mounting Fisher Price transmissions
We mount the fisher price transmissions which control our arms in a similar fashion.
The shaft they turn keeps them in place, locked up against the square tubing (in our case, 1.5"x1"). Shaft collars keep the transmissions from sliding out (off the shaft). To turn the shaft (1/8" keyway shaft), we machine an octagon hub/block that picks up the octagon shape of the inside of the fisher price output. The hub is then bored to the shaft diameter and an 1/8" keyway is broached. Hose clamps are used to hold the white plastic output of the fisher price transmission to the octagon hub to avoid slippage. Last edited by ShaneP : 26-01-2010 at 13:54. Reason: not hex, i meant octagon, my mistake |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP! Looking for Fisher-Price Mounting Screws | Graham Donaldson | Motors | 2 | 04-12-2008 14:15 |
| fisher price | Futbol.195 | Electrical | 8 | 20-01-2008 16:47 |
| Mounting Fisher Price Gearboxes | Bochek | Technical Discussion | 8 | 09-02-2007 16:34 |
| Mounting / Connecting The Fisher Price Motor | Xufer | Motors | 21 | 31-01-2006 20:16 |
| Fisher Price Motor Mounting | Ashley Weed | Motors | 1 | 16-02-2003 19:29 |
Threaded Mode