|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
|
||||
|
||||
|
Re: Restrainting pin question
ahh. i didn't see that. But it was for a prototype. we've already scraped that, but what we did to provent the piston from bending out of line was we had them slide through two blocks that the lock on the moving arm sit inbetween. so it had those to hold it in place and provent shearing pressure
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RC +5V Pin Voltage | adam2177 | Electrical | 6 | 18-02-2008 13:07 |
| Tx/Rx pin layout? | EHaskins | FIRST Tech Challenge | 1 | 27-02-2006 10:18 |
| Pin Trading | Astronouth7303 | Chit-Chat | 12 | 14-05-2004 14:20 |
| Dutch Pin | patrickrd | Technical Discussion | 5 | 03-03-2002 12:27 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |