3-axis Joystick

jhersh · #1 27-01-2010, 01:37

I know the Logitech 3D joystick works great. The thrustmaster one probably does, but I haven't tested it.

Any USB joystick that is either HID compliant or for which you have installed DirectInput drivers for will work with the Driver Station.

-Joe

Ether · #2 27-01-2010, 10:11

Quote:

Originally Posted by jhersh

I know the Logitech 3D joystick works great
...
Any USB joystick that is either HID compliant or for which you have installed DirectInput drivers for will work with the Driver Station.

-Joe

Are you using this joystick with LabVIEW?

~

jhersh · #3 27-01-2010, 16:19

Quote:

Originally Posted by Ether

Are you using this joystick with LabVIEW?

Yes.

Ether · #4 27-01-2010, 16:35

Quote:

Originally Posted by jhersh

Yes.

Does the 2010 FRC LabVIEW installation come with built-in support for the Logitech 3-axis joystick? If not, are the modifications straightforward for a novice?

Thank you.

~

jhersh · #5 27-01-2010, 17:02

Quote:

Originally Posted by Ether

Does the 2010 FRC LabVIEW installation come with built-in support for the Logitech 3-axis joystick? If not, are the modifications straightforward for a novice?

It's supported out of the box. It supports up to 6 axes on each joystick.

-Joe

dmitch · #6 05-02-2010, 20:50

I know that the Logitech 3D works great with LabView. Me and the other programmer on my team got it working great with the Holonomic Drive and the Mecanums.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
joystick axis in labview	frcchile	NI LabVIEW	7	20-02-2009 12:06
Axis 3 on joystick	camper365	Programming	3	13-02-2009 22:49
pwm outputs vs. joystick y-axis	stephenthe1	Programming	4	01-12-2004 17:29
Inverting Y axis on joystick	FormatteD_C	Programming	7	24-02-2004 16:56
switching joystick axis?????	team222badbrad	Technical Discussion	9	16-01-2002 23:07