|
|
|
 Unsure if I'll get it to work, but that's no reason to not try. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Unsure if I'll get it to work, but that's no reason to not try. - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Getting started with CAN/Jaguar
Are there any good explanations of the use of CAN/Jaguar and how to implement it out there?
|
|
#2
27-01-2010, 23:43
|
|||
|
|||
|
Re: Getting started with CAN/Jaguar
There are many sources I can think of that you should examine. A few I can think of off the top of my head are:
1. The Black Jaguar (MDL-BDC24) data sheet available from Luminary Micro. This contains information as to how to wire the CAN bus and tells a little about what is available. Other documents on their site might also help you. 2. To actually implement it take a look at the sample code (for Java, C++ and Labview) on FirstForge (firstforge.wpi.edu). Just examining the sample code should be able to allow you to gain enough knowledge to experiment with it and figure more out. Hope that helps, -Ian |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can I control a victor/jaguar with an RC receiver | Bruceb | Electrical | 3 | 30-12-2008 10:50 |
| Help Getting Started with VEX programming. | Joe Johnson | VEX | 5 | 16-04-2007 09:01 |
| Problem getting started with USB 6009 | JimGRobot | LabView and Data Acquisition | 1 | 18-12-2006 09:15 |
| Getting Started with Scripting | LBK Rules | Programming | 2 | 15-01-2005 01:28 |
Linear Mode
