|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Alright so our team, team 2386 got all the updates for the software and driver station. Today I updated the cRio to v19 and we finally got the programming laptop able to download code. Then when we went to test the code nothing happened. There was a green light for Robot Code, but I was unable to use the robot. Anyone have any ideas?
|
|
#2
|
|||||
|
|||||
|
Re: Code downloaded but not working... :(
Did you click the "Enable" button on the Driver Station to enable the robot?
|
|
#3
|
|||
|
|||
|
Re: Code downloaded but not working... :(
Haha yea I tried all the modes and enabled them all. No luck on all fronts.
|
|
#4
|
|||||
|
|||||
|
Re: Code downloaded but not working... :(
Quote:
Can you describe what the Robot Status Light is doing when you try to run your program? |
|
#5
|
|||
|
|||
|
Re: Code downloaded but not working... :(
Sorry about this thread, I found the error while re-reading the documentation. The electrical was screwed up. We got the robot working.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C++ Sample Code not working... | hm29168 | CAN | 5 | 27-01-2010 20:59 |
| Downloaded program, but no response | program1 | Programming | 4 | 10-01-2009 18:42 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| Incrementation Code not working | benhulett | Programming | 6 | 12-02-2007 17:39 |
| frc_camera not working but labview does | Issues | Programming | 7 | 18-01-2006 19:23 |